Description
- Always Fresh
- Water Activated
- Hits High PPM’s
- Inexpensive Start-Up
- Doesn’t Produce Heat
- No Equipment Needed
- Slows CO2 Release At Night
The Enhancer CO2 – Set Up Instructions
1). Remove lid and add 1 litre (4 cups) of lukewarm water.
2). Place lid back on and remove the sticker.
3). Shake canister well while covering the hole on lid.
4). Hang the canister above the desired plants in an upright position.
CO2 being a heavier air will cascade down over the plants.Place an oscillating fan to evenly spread the CO2 around the room. Higher CO2 levels allow the plants to handle higher temperatures. If exhausting, place The Enhancer as far away from the vent as possible.
Reviews
There are no reviews yet.